Fix Ps4 Pro Overheating Issues

Unplug your ps4 pro console.

Fix ps4 pro overheating issues. Clean up the usb ports as well. Just be careful with the joints and the cover should come off quite easily. Flip the ps4 over to the hard drive side and remove the half cover carefully.

If you happen to have a compressed can air then gently use it through the openings on your ps4. Select install update if there is any update available. Wait a few minutes and reconnect the modem and router to its power source.

Lastly ive seen some ps4s that actually overheat because of faulty solder joints between the apu and motherboard. This is a fairly common cause of ps4s overheating as well. Httpswwwfasttechcaplaystation 4 partstorx t8h security screwdriver phillips screwdriver.

These instructions pertain to all versions of the ps4 hardware including the original playstation 4 the ps4 slim and the ps4 pro. Select check for update on the options menu. If you know some basic electronics open your ps4 and using a compressed air spray for electronics clean very carefully all the components.

Press the options button on the controller. Clean your ps4 with a fiber cloth. Follow our troubleshooting procedure to fix your ps4 overheating problem.

When your ps4 is overheating youll usually see a message like this. Then if you want to go further buy a new thermal paste for your cpu and gpu and apply between them and the sinks. Unplug and re plug power down your ps4 and unplug it from its power source.

Then unplug your modem and router. Torx t8h screwdriver. Open all those screws carefully using philips screwdrivers.

Though the ps4 comes with built in fans and in take vents but if theres air able to come into those vents you risk your ps4 overheating. When i bought ps4 i noticed that after a few minutes of playing killzone my ps4 is turning in to hairdryeri could send it to sony service but i stated that if console works the problem must be in cooling system. Playstation 4 overheating problem solution.

To get to the thermal paste you will have to remove the reach the motherboard first. Try and leave as much space as you can around the sides. If there is not an update it will notify you.